Rear Seat Backrest - Bench Seat, Second Row
REAR SEAT BACKREST - BENCH SEAT, SECOND ROWRemoval and Installation
1. Remove the second row bench seat.
2. Using a suitable tool, carefully pry the LH side shield for access to the recliner handle clip and remove the clip and the LH recliner handle.
3. If equipped, access the pivot handle clip from the bottom side of the LH side shield and remove the clip and the LH pivot handle.
4. Remove the 4 screws and the LH side shield.
5. Using a suitable tool, carefully pry the RH side shield for access to the recliner handle clip and remove the clip and the RH recliner handle.
6. If equipped, access the pivot handle clip from the bottom side of the RH side shield and remove the clip and the RH pivot handle.
7. Remove the 4 screws and the RH side shield.
8. Remove the bolt and the LH safety belt buckle.
- To install, tighten to 58 Nm (43 lb-ft).
9. Disconnect the cushion release cables.
1 Release the RH cable end.
2 Release the RH cable from the anchor retainer.
3 Release the LH cable end.
4 Release the LH cable from the anchor retainer.
10. Remove the 2 LH backrest-to-cushion bolts.
- To install, tighten to 58 Nm (43 lb-ft).
11. Remove the bolt and the RH safety belt buckle.
- To install, tighten to 58 Nm (43 lb-ft).
12. Remove the 2 RH backrest-to-cushion bolts and remove the backrest from the cushion.
- To install, tighten to 58 Nm (43 lb-ft).
13. To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.