Fog/Driving Lamp: Service and Repair

FOG LAMP












Removal and Installation

NOTE: Make sure the headlamp switch and ignition switch are in the OFF position.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 8 fender splash shield screws.
3. Remove the 6 pin-type retainers and the fender splash shield.
4. Disconnect the fog lamp electrical connector.
5. Remove the 4 screws and the fog lamp.
- To install, tighten to 5 Nm (44 lb-in).

6. To install, reverse the removal procedure.