Pressure Feedback Exhaust Sensor: Service and Repair

EXHAUST GAS RECIRCULATION (EGR) SYSTEM MODULE







Exploded View

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the exhaust gas recirculation (EGR) system module-to-exhaust manifold tube upper nut.
- To install, tighten to 40 Nm (30 lb-ft).

4. Disconnect the EGR system module-to-exhaust manifold tube lower nut and remove the EGR system module-to-exhaust manifold tube.
- To install, tighten to 40 Nm (30 lb-ft).

5. Disconnect the EGR system module electrical connector.
6. Disconnect the EGR system module vacuum connector.

7. NOTE:
- The EGR system module gasket sealing surfaces are soft metals.
- Do not reuse the EGR system module gasket.

Remove the 2 bolts and the EGR system module.
- Remove and discard the EGR system module gasket.
- Carefully clean the EGR system module gasket sealing surfaces.
- To install, tighten to 25 Nm (18 lb-ft).







8. To install, reverse the removal procedure.
- Install a new EGR system module gasket with the side with the raised circle facing the intake manifold.