Window Glass: Adjustments

DOOR WINDOW GLASS ADJUSTMENT

1. Remove the front door trim panel and watershield.







2. Partially lower the front door window glass to within 75 mm (2.95 in) of the full UP position.







3. Loosen the nut and washer assemblies.
4. Open the front door.
5. Gently pull the front door window glass fully rearward into the door top glass run.







6. Tighten the nut to 8 Nm (71 lb-in).

7. NOTE: If the hole is a vertical slotted hole, make sure that the nut and washer assembly is positioned at the bottom of the slot before downward pressure is applied to the window regulator equalizer arm bracket.

Apply downward pressure on the window regulator equalizer arm bracket.







8. Tighten the nut to 8 Nm (71 lb-in).
9. Cycle the front door window glass to make sure of correct operation. Readjust the height if necessary.
10. Install the front door trim panel and watershield.