6R60 Selector Lever Cable Adjustment
Selector Lever Cable Adjustment 6R601. With the vehicle in NEUTRAL, position the vehicle on a hoist.
2. Place the range selector in the first position all the way toward the rear of the vehicle.
3. Move the range selector forward 3 detents. This should be the (D) position.
4. Remove the cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot.
5. Disconnect the transmission shift cable from the manual control lever.
6. Rotate the manual lever clockwise until the travel stops. Then rotate the manual lever counterclockwise 3 detents, this should be the (D) position.
7. With the range selector lever cable end disconnected, unlock the tab on the range selector lever cable end by sliding it up.
8. Carry out the following adjustment on the range selector lever cable end:
1 Make sure that the range selector lever cable end slides forward and backwards.
2 Connect the range selector lever cable end onto the manual control lever.
3 Lock the range selector lever cable end into place by pressing the lock tab down.
9. NOTE: If the shield is loose on the cable, install a new cable shield.
Install and secure the cable shield.
10. Verify that the engine will start in PARK and NEUTRAL. Verify that the reverse lamps will illuminate in the REVERSE position. If not, check the adjustment of the transmission range TR sensor.