Turbine Shaft Speed (TSS) Sensor
Turbine Shaft Speed (TSS) SensorRemoval
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
4x4 vehicles
2. Disconnect the front driveshaft from the transfer case.
3. Disconnect the front driveshaft from the front differential.
4. Remove the front driveshaft from the vehicle.
All vehicles
5. Remove the cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot.
6. Remove the shift cable and bracket.
7. Disconnect the turbine shaft speed (TSS) sensor electrical connector.
8. Remove the TSS sensor.
1 Remove the TSS sensor screw.
2 Remove the TSS sensor from the transmission.
^ Inspect the TSS sensor O-ring for damage. If damaged, install a new O-ring.
Installation
All vehicles
1. Inspect the O-ring seal for damage. Install a new seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to the O-ring seal.
1 Install the TSS sensor into the transmission.
2 Tighten the TSS sensor screw.
^ Tighten to 14 Nm (10 ft. lbs.).
2. Connect the TSS sensor electrical connector.
3. Install the shift cable and bracket.
^ Tighten to 40 Nm (30 ft. lbs.).
4. NOTE: If the shield is loose on the cable, replace the shield.
Install the cable shield.
4x4 vehicles
5. Install the front driveshaft in the vehicle.
6. Install the front driveshaft to the transfer case.
^ Tighten to 30 Nm (22 ft. lbs.).
7. Install the front driveshaft to the front differential.
^ Tighten to 18 Nm (13 ft. lbs.).