Cooling System Flushing

Cooling System Flushing

Material:

All vehicles

1. WARNING: To avoid personal injury, do not unscrew the radiator cap while the engine is operating or hot. The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may result in personal injury.

Drain the cooling system.





Vehicles equipped with a 4.0L SOHC engine
2. Remove the bolts, thermostat housing cover and thermostat. Install the thermostat housing cover and bolts without the thermostat.
^ Tighten to 10 Nm (89 inch lbs.).

Vehicles equipped with a 4.6L (3V) engine
3. Remove the throttle body.





4. Disconnect the fuel vapor hose.





5. Remove the bolts, thermostat housing cover and thermostat. Install the thermostat housing cover, the O-ring seal and the bolts without the thermostat.
^ Tighten to 10 Nm (89 inch lbs.).

All vehicles
6. Using a suitable cooling system flushing tool, flush the engine and radiator.
^ Use cooling system flush.





Vehicles equipped with a 4.0L SOHC engine

7. NOTE: Prior to installing the thermostat, inspect the thermostat housing cover O-ring seal and install a new gasket if necessary.

Install the thermostat, O-ring seal, thermostat housing cover and bolts.
^ Tighten to 10 Nm (89 inch lbs.).





Vehicles equipped with a 4.6L (3V) engine

8. NOTE: Prior to installing the thermostat, inspect the thermostat housing cover O-ring seal and install a new O-ring seal if necessary.

Install the thermostat, O-ring seal, thermostat housing cover and bolts.
^ Tighten to 10 Nm (89 inch lbs.).





9. Connect the fuel vapor hose.
10. Install the throttle body.

All vehicles
11. Fill and bleed the cooling system.