Steering Column Multifunction Switch

Steering Column Multifunction Switch





Removal and Installation

CAUTION: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.

1. Disconnect the battery ground cable.





2. Remove the 2 screws and the steering column opening cover.
3. Remove the 3 screws and the upper and lower steering column shroud.
4. Disconnect the multi-function switch electrical connector.
5. Remove the 2 multi-function switch screws and the multi-function switch.
^ To install, tighten to 3 Nm (27 inch lbs.).

6. To install, reverse the removal procedure.