Seat Cushion - Front

SEAT CUSHION - FRONT

Worldwide Diagnostic System (WDS):

Special Tool(s)

Driver Seat Cushion (Part 1):

Driver Seat Cushion (Part 2):

Passenger Seat Cushion (Part 1):

Passenger Seat Cushion (Part 2):

Disassembly and Assembly

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- Never probe the connector on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- LH seat shown, RH seat similar.

All seats
1. Remove the front seat and depower the supplemental restraint system (SRS).
2. Remove the seat track.
3. Remove the front seat backrest.

4. CAUTION: Use care when separating the seat back trim cover from the hook and loop strip, or the hook and loop strip can be torn from the backrest foam pad.

Release the hook and loop strips, remove the hog rings and separate the cushion trim cover from the cushion foam pad.

Seat with heat
5. If necessary, remove the cushion heated seat mat and route out the wire harness through the cushion foam pad opening.

All seats
6. To assemble, reverse the disassembly procedure.
7. Install the front seat backrest.
8. Install the seat track.
9. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.

Passenger seat
10. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS. Zero Seat Weight Test