Attachment III - Technical Information

MODULE RECALIBRATION

1. Verify that the scan tool (Vehicle Communication Module [VCM] with Integrated Diagnostic System [IDS], Portable Diagnostic Software [PDS] or equivalent) is updated to software release 47.4 or later.

2. Recalibrate the PCM and transmission control module (TCM) to the latest level using the VCM and either the IDS or the PDS.

^ If the calibration process was successful, proceed to Authorized Modifications Label Installation instructions in this Attachment III.

^ If unable to calibrate the PCM:

- module replacement will not be covered under this program, and

- prior to disconnecting the scan tool and closing the session, call the Special Service Support Center for further Instructions.

AUTHORIZED MODIFICATIONS LABEL INSTALLATION





1. Obtain and prepare the Authorized Modifications Label. Describe the modification performed, and enter your P&A Code, date of repair and the program type and program number. See Figure 1.

PROOF OF CORRECTION CERTIFICATE





1. Provide the owners of vehicles registered in California and Massachusetts with a completed "Vehicle Emission Recall - Proof of Correction" certificate. See Figure 2.