Keyless Entry Transmitter: Service and Repair

SLIDING DOOR LATCH REMOTE CONTROL

Removal and Installation
1. Remove the sliding door trim panel.
2. Remove the 3 sliding door latch screws.
- To install, tighten to 9 Nm (80 lb-in).

3. Position the sliding door latch outside of the door frame.
- If equipped, disconnect the sliding door detent switch electrical connector.

4. Remove the 3 sliding door remote control bolts from the inside of the door frame.
- To install, tighten to 9 Nm (80 lb-in).

5. Remove the 3 sliding door remote control bolts.
- To install, tighten to 9 Nm (80 lb-in).

6. Open the clip and disconnect the sliding door exterior handle actuating rod.
7. Open the clip and disconnect the sliding door interior handle actuating cable.
8. Position the sliding door remote control.
9. Disconnect the sliding door lock actuator and if equipped the sliding door latch actuator electrical connector(s).
10. Remove the sliding door remote control.
11. To install, reverse the removal procedure.