Seat Cushion - Second Row, Bucket
SEAT CUSHION - SECOND ROW, BUCKETPart 1:
Part 2:
Disassembly and Assembly
NOTE: LH seat shown, RH seat similar.
1. Remove the second row bucket seat.
2. Remove the second row bucket seat backrest.
3. Remove the 9 screws and the seat bottom cover.
4. Remove the 6 seat riser-to-seat track nuts and remove the seat riser.
- To install, tighten to 25 Nm (18 lb-ft).
5. CAUTION: When installing a new seat riser strut, make sure to install all the parts in the service kit.
NOTE:
- When installing the seat riser strut, make sure the rod end is toward the front of the seat to correctly position the offset.
- For additional information, refer to Seat - Exploded View, Second Row, Bucket Seat for the correct location of the seat riser strut washer and bushing.
If necessary, remove the 2 bolts (1 shown) and the seat riser strut.
- To install, tighten to 25 Nm (18 lb-ft).
6. Remove the 4 seat track-to-cushion pan bolts and remove the seat track from the seat cushion.
- To install, tighten to 25 Nm (18 lb-ft).
7. Remove the 2 bolts and the lower anchors and tethers for children (LATCH).
- To install, tighten to 50 Nm (37 lb-ft).
8. Release the J-clips and remove the seat cushion trim cover and foam pad from the seat cushion pan.
9. CAUTION: Use care when separating the seat upholstery from the hook and loop strip or the hook and loop strip can be torn from the seat cushion foam pad.
Separate the seat cushion trim cover and foam pad hook and loop fasteners.
10. Remove and discard all the hog rings and remove the seat cushion trim cover from the foam pad.
11. To assemble, reverse the disassembly procedure.