Seat - Front

SEAT - FRONT







Removal and Installation

WARNING:
- Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Move the seat fully REARWARD.
2. Remove the 2 seat track-to-floor front bolts and washers.
3. Move the seat fully FORWARD.
4. Depower the SRS.







5. Remove the 2 seat track-to-floor nut covers by unscrewing the caps.
6. Remove the 2 seat track-to-floor rear nuts and washers.
7. Tilt the seat rearward and disconnect the electrical connectors beneath the seat.
8. Carefully remove the seat from the vehicle.

Installation
1. Position the seat in the vehicle.
2. Connect the electrical connectors beneath the seat.
3. Install the 2 seat track-to-floor rear nuts and washers.
- Tighten to 55 Nm (41 lb-ft).

4. Install the 2 seat track-to-floor nut covers.
5. Repower the SRS.
6. Move the seat fully REARWARD.
7. Install the 2 seat track-to-floor front bolts and washers.
- Tighten to 23 Nm (17 lb-ft).
- Make sure the safety belts and buckles are accessible to the occupants after installation.