Compressor Manifold and Tube Assembly
COMPRESSOR MANIFOLD AND TUBE ASSEMBLYRemoval and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of system contamination from a failed A/C compressor or damage to the suction accumulator.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the suction accumulator outlet fitting nut.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).
4. Remove the auxiliary line fitting nut.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).
5. Remove the compressor manifold and tube bracket bolt.
6. Disconnect the high pressure switch electrical connector.
7. Remove the compressor manifold bolt.
- Discard the O-ring seals.
- To install, tighten to 21 Nm (15 lb-ft).
8. Remove the condenser inlet fitting nut.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).
9. Remove the compressor manifold and tube assembly.
10. To install, reverse the removal procedure.
- Install new O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Evacuate, leak test and charge the refrigerant system.