Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)

Part 1:

Part 2:

Removal

1. NOTE: Any PCM replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement DOES NOT require new keys.

Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure.

2. Remove the 3 bolts and position aside the suction accumulator.
3. Remove the bolt and position aside the power steering reservoir.
4. Loosen the bolt and disconnect the PCM electrical connector.
5. Remove the 2 PCM retaining nuts and the PCM.

Installation
1. Install the PCM and the 2 retaining nuts.
- Tighten to 5 Nm (44 lb-in).

2. Connect the PCM electrical connector and tighten the bolt.
- Tighten to 7 Nm (62 lb-in).

3. Position the power steering reservoir and install the bolt.
- Tighten to 10 Nm (89 lb-in).

4. Position the suction accumulator and install the 3 bolts.
- Tighten to 5 Nm (44 lb-in).

5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure.
6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure.