Heated Seat Module

HEATED SEAT MODULE

Front Seat Cushion - Driver (Part 1):

Front Seat Cushion - Driver (Part 2):

Front Seat Cushion - Passenger (Part 1):

Front Seat Cushion - Passenger (Part 2):

Front Seat Backrest (Part 1):

Front Seat Backrest (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the affected seat and depower the SRS.
2. Disconnect the heated seat module electrical connector.
3. Detach and remove the heated seat module.
4. To install, reverse the removal procedure.
5. Install the affected seat and repower the SRS.