Seat Recliner - Outboard, Second Row, 60 Percent E-Z Entry
SEAT RECLINER - OUTBOARD, SECOND ROW, 60 PERCENT E-Z ENTRYSecond Row, 60 Percent E-Z Entry Backrest (Part 1):
Second Row, 60 Percent E-Z Entry Backrest (Part 2):
Second Row, 60 Percent, E-Z Entry Cushion (Part 1):
Second Row, 60 Percent E-Z Entry Cushion (Part 2):
Second Row, 40 Percent E-Z Entry Backrest:
Second Row, 40 Percent, E-Z Entry Cushion (Part 1):
Second Row, 40 Percent, E-Z Entry Cushion (Part 2):
Second Row, Bucket, Backrest:
Second Row, Bucket, Cushion (Part 1):
Second Row, Bucket, Cushion (Part 2):
Second Row, 60 Percent Bench, Backrest (Part 1):
Second Row, 60 Percent Bench, Backrest (Part 2):
Second Row, 60 Percent Bench, Cushion (Part 1):
Second Row, 60 Percent Bench, Cushion (Part 2):
Second Row, 40 Percent Bench, Backrest (Part 1):
Second Row, 40 Percent Bench, Backrest (Part 2):
Second Row, 40 Percent Bench, Cushion:
Exploded View
Removal
1. Remove the second row, 60 percent E-Z entry seat from the vehicle.
2. Remove the second row, 60 percent E-Z entry seat backrest.
3. Remove 3 screws, recliner handle and outboard recliner outer cover.
4. Remove the 2 outboard recliner-to-backrest frame bolts.
5. NOTE: When pulling outboard recliner out, note keyed position of recliner release shaft as it may pull out of inboard recliner.
Remove 2 outboard recliner-to-cushion frame bolts, pull out and separate the outboard recliner.
6. Remove the outboard recliner inner cover.
7. Remove the outboard recliner.
1. Rotate the cable casing out of the outboard recliner.
2. NOTE: The cable ends are color coded/keyed to the levers.
Rotate the cable ends out of the outboard recliner levers.
3. Remove the outboard recliner.
Installation
1. If necessary, position the recliner release shaft onto the inboard recliner release pivot stub.
2. NOTE: The cable ends are color coded/keyed to the levers.
Position each keyed cable end to the outboard recliner lever and rotate into position.
- Install the cable casing to the outboard recliner.
3. Install the outboard recliner inner cover.
4. Position the outboard recliner release pivot stub into the recliner shaft.
5. Install the 2 outboard recliner-to-cushion frame bolts.
- Tighten to 55 Nm (41 lb-ft).
6. Install the second row, 60 percent E-Z entry seat backrest.
7. Install the second row, 60 percent E-Z entry seat into the vehicle.
8. Cycle the backrest down and then back to the upright position. Make sure the inboard and outboard recliners simultaneously and securely lock in the upright position.