Reverse Servo Assembly
Reverse Servo AssemblyDisassembly
1. Remove the control valve spring retainer.
2. Remove the reverse servo spring and check valve.
3. WARNING: The upper and lower servo covers are under spring tension. Use care when separating the 2 halves. Failure to follow these instructions can result in personal injury.
NOTE: Tabs on servo plate mate with slots on cover every 120 degrees.
Remove the reverse servo plate by turning in either direction to release.
^ Align the arrow on the servo plate with any slot on the cover.
4. Remove the reverse servo spring.
5. Remove the reverse servo piston and seal assembly.
^ Inspect the seal for damage, install a new reverse servo piston if necessary.
6. Remove and discard the reverse servo piston seal.
Assembly
1. NOTE: Try not to roll the seal onto the housing when installing the seal, or damage to the seal can occur.
Lubricate and install a new reverse servo piston seal.
2. Lubricate and install the reverse servo piston and seal assembly.
3. Install the reverse servo spring.
4. WARNING: The upper and lower servo covers are under spring tension. Use care when assembling the 2 halves. Failure to follow these instructions can result in personal injury.
CAUTION: The arrow on the servo plate must be aligned evenly between any 2 slots on the cover.
Install the reverse servo plate.
5. Install the reverse servo spring and check valve.
6. Install the control valve spring retainer.
^ Tighten to 10 Nm (89 inch lbs.)
