Sunroof / Moonroof: Adjustments

ROOF OPENING PANEL ALIGNMENT

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including: whenever the roof opening panel motor has been removed from the roof panel system, the roof opening panel glass has been removed from the roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. Refer to Roof Opening Panel Motor Initialization. Programming and Relearning

1. Cycle the roof opening panel to the VENT position.







2. Loosen the roof opening panel glass screws.
- Loosen only the front screws to adjust the front.
- Loosen only the rear screws to adjust the rear.

3. Cycle the roof opening panel in the following sequence: OPEN, CLOSE, VENT, CLOSE.







4. Adjust the roof opening panel glass to specification.
5. Cycle the roof opening panel to the VENT position.







6. Tighten the roof opening panel glass screws.
- Tighten to 4 Nm (35 lb-in).