Seat - Second Row, Bucket

SEAT - SECOND ROW, BUCKET

Material:

Material







Removal and Installation

NOTE: LH seat shown, RH seat similar.

1. Remove the 2 rubber bolt caps.
2. Remove the 2 seat mounting nuts.
- To install, tighten to 40 Nm (30 lb-ft).

3. Fold the affected bucket seat up to the E-Z entry position.
4. Pull up to release and remove the floor riser trim cover.
5. Remove the safety belt buckle bolt and the safety belt buckle.
- To install, apply threadlock and tighten to 47 Nm (35 lb-ft).

6. Remove the 3 seat mounting bolts.
- To install, apply threadlock and tighten to 40 Nm (30 lb-ft).

7. Remove the bucket seat.
8. To install, reverse the removal procedure.
- When installing any seat-to-floor bolts or studs, apply threadlock.