Intermediate Shaft Speed Sensor
Intermediate Shaft Speed SensorRemoval
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
Four wheel drive (4WD) vehicles
2. Disconnect the front driveshaft from the transfer case.
3. Disconnect the front driveshaft from the front differential.
4. Remove the front driveshaft from the vehicle.
All vehicles
5. Remove the cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot.
6. Remove the selector lever cable and bracket.
7. Disconnect the intermediate shaft speed sensor electrical connector.
8. Remove the intermediate shaft speed sensor.
1 Remove the intermediate shaft speed sensor screw.
2 Remove the intermediate shaft speed sensor from the transmission.
^ Inspect the intermediate shaft speed sensor O-ring for damage. If damaged, install a new O-ring.
Installation
All vehicles
1. Inspect the O-ring seal for damage. Install a new seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to the O-ring seal.
1 Install the intermediate shaft speed sensor into the transmission.
2 Tighten the intermediate shaft speed sensor screw.
^ Tighten to 14 Nm (10 ft. lbs.)
2. Connect the intermediate shaft speed sensor electrical connector.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the cable end is correctly installed.
Install the selector lever cable and bracket.
^ Tighten to 40 Nm (30 ft. lbs.)
4. NOTE: If the shield is loose on the cable, replace the shield.
Install the cable shield.
4WD vehicles
5. Install the front driveshaft in the vehicle.
6. Install the front driveshaft to the transfer case.
^ Tighten to 30 Nm (22 ft. lbs.)
7. Install the front driveshaft to the front differential.
^ Tighten to 18 Nm (13 ft. lbs.)
