Operation CHARM: Car repair manuals for everyone.
Home >> Mercury Truck >> 2008 >> Mariner 4WD L4-2.3L VIN Z >> Repair and Diagnosis >> Powertrain Management >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair

Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)







Removal

1. NOTE: Any powertrain control module (PCM) replacement will require that ALL customer keys are available to be programmed at the time of installation. PCM replacement DOES NOT require new keys.

Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation procedure.

2. Remove the powertrain control module (PCM) stud bolt nut and position the wiring harness aside.
3. Disconnect the 3 PCM electrical connectors.
4. Remove the 2 stud bolts and the PCM.
5. Remove the PCM cowl seal.

Installation
1. Install the PCM cowl seal.
2. Install the PCM and the 2 stud bolts.
- Tighten to 6 Nm (53 lb-in).

3. Connect the 3 PCM electrical connectors.
4. Position the wiring harness and install the PCM stud bolt nut.
- Tighten to 6 Nm (53 lb-in).

5. Restore the module configuration. Carry out module configuration restore steps of the Programmable Module Installation procedure.
6. Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure.
pro multis · About Operation CHARM