Power Transfer Unit (PTU) Draining and Filling - Manual Transaxle

Power Transfer Unit (PTU) Draining and Filling - Manual Transaxle

Material:

CAUTION: New power transfer unit (PTU) lubricant must be installed any time the PTU has been submerged in water.

NOTE: The power transfer unit (PTU) is lubricated for life and is not to be checked unless a leak is suspected.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.

2. NOTE: The fluid level must be even with the bottom of the filler hole with the vehicle on flat, level ground.

Remove the fill plug and fill the PTU with rear axle lubricant.





3. Install the fill plug and gasket.
^ Tighten to 48 Nm (35 lb-ft).