Compressor to Condenser Discharge Line

COMPRESSOR TO CONDENSER DISCHARGE LINE







Removal and Installation

NOTE: Installation of a new receiver/drier is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the receiver/drier.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover refrigerant.
3. Remove the RH lower engine splash shield.







4. Remove the front bumper cover.
5. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.
- To install, tighten to 15 Nm (11 lb-ft).

6. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring and gasket seals.
- To install, tighten to 15 Nm (11 lb-ft).

7. Remove the compressor-to-condenser discharge line.
8. To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.

9. Evacuate, leak test and charge the refrigerant system.