Evaporator Outlet Line

EVAPORATOR OUTLET LINE







Removal and Installation

NOTE: Installation of a new receiver/drier is not required when repairing the air conditioning system, except when there is physical evidence of contamination from a failed A/C compressor or damage to the receiver/drier.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the RH lower engine splash shield.







4. Remove the A/C compressor suction fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.
- To install, tighten to 15 Nm (11 lb-ft).

5. Detach the wire harness clip from the evaporator outlet line.
6. Remove the thermostatic expansion valve (TXV) fitting nut and disconnect the fitting.
- Discard the gasket seals.
- To install, tighten to 15 Nm (11 lb-ft).

7. Disconnect the low-charge protection switch electrical connector.
8. Detach the evaporator outlet line from the receiver/drier bracket.
9. Remove the evaporator outlet line.
10. To install, reverse the removal procedure.
- Install new gasket seals and a new O-ring seal.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.

11. Evacuate, leak test and charge the refrigerant system.