Catalyst Monitor Sensor

CATALYST MONITOR SENSOR

Exploded View







Special Tool(s)

Special Tool(s):

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 7 bolts (5 shown) and the LH splash shield.
- To install, tighten to 10 Nm (89 lb-in).







3. Disconnect the catalyst monitor sensor electrical connector and detach the wiring retainer(s).

4. NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.

Using the special tool, remove the catalyst monitor sensor.
- To install, tighten to 48 Nm (35 lb-ft).







5. NOTE: Apply a light coat of anti-seize lubricant to the threads of the catalyst monitor sensor.

To install, reverse the removal procedure.