Tie Rod End - Inner
Tie Rod End - InnerSpecial Tool(s):
Removal and Installation
1. Remove the wheel and tire.
2. Turn the steering wheel fully in the direction of the inner tie-rod end that is being removed.
3. Loosen the tie-rod end jam nut.
^ To install, tighten to 40 Nm (30 lb-ft).
4. Remove and discard the outer tie-rod end nut.
^ To install, tighten to 80 Nm (59 lb-ft).
5. Using the special tool, separate the outer tie-rod end from the wheel knuckle and remove the tie rod.
6. Remove the tie-rod end jam nut.
7. Remove and discard the boot clamps and the steering gear boot.
8. Using a suitable tool, hold the steering gear rack.
9. Using a suitable tool, remove the inner tie-rod end.
^ To install, tighten to 100 Nm (74 lb-ft).
10. NOTE: Using a suitable tool, hold the steering gear rack while tightening the inner tie rod.
To install, reverse the removal procedure.
11. Check and, if necessary, adjust the front toe.