Shifter M/T: Service and Repair

Gearshift Lever

Gearshift Lever:

Removal
1. Remove the gearshift lever knob and boot assembly.
2. Remove the floor console finish panel.
3. Remove the 2 gearshift cable clips.





4. Carefully disconnect the gearshift cables from the gearshift lever.
5. Remove the 4 gearshift lever nuts.
6. Remove the gearshift lever.

Installation
1. Position the gearshift lever.
2. Connect the gearshift cables to the gearshift lever.








3. CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.

Install the 2 gearshift cable clips.





4. Install the 4 gearshift lever nuts.
^ Tighten to 25 Nm (18 lb-ft).

5. Adjust the gearshift cables.
6. Install the floor console finish panel.
7. Install the gearshift lever knob and boot assembly.