Front Door Window Regulator: Service and Repair

WINDOW REGULATOR - FRONT DOOR

Exploded View







Removal and Installation
1. Remove the front door trim panel.
2. Remove the screw and the front door trim panel bracket.







3. Remove the 3 pushpins and pad assembly.







4. Position the watershield aside.
5. Connect the window control switch electrical connector.
6. Using the window control switch, lower the front door window glass to gain access to the front door window glass screws.
7. Disconnect the window control switch electrical connector.
8. Remove the 2 front door window glass screws.
- To install, tighten to 5 Nm (44 lb-in).







9. Support the front door window glass in the full up position with tape.
10. Disconnect the front door window motor electrical connector.
11. Remove the front door window regulator and motor bolt.
- To install, tighten to 11 Nm (8 lb-ft).







12. Loosen the 2 front door window regulator and motor bolts.
- To install, tighten to 11 Nm (8 lb-ft).







13. Remove the 2 nuts and the front door window regulator and motor.
- To install, tighten to 11 Nm (8 lb-ft).







14. To install, reverse the removal procedure.