Compressor to Condenser Discharge Line

COMPRESSOR TO CONDENSER DISCHARGE LINE







Removal and Installation
1. Recover the refrigerant.
2. Remove the compressor-to-condenser discharge line bracket nut and detach the bracket.
- To install, tighten to 7 Nm (62 lb-in).

3. Remove the compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.
- To install, tighten to 15 Nm (11 lb-ft).

4. Disconnect the A/C pressure transducer electrical connector.
5. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).

6. Remove the compressor-to-condenser discharge line.
7. To install, reverse the removal procedure.
- Install a new gasket seal and O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.

8. Evacuate, leak test and charge the refrigerant system.