Brake Switch (Cruise Control): Service and Repair

SPEED CONTROL DEACTIVATOR SWITCH







Removal

CAUTION: Do not remove or repair the brake pedal, brake booster or master cylinder without first removing the speed control deactivator switch. Do not install the speed control deactivator switch without the brake pedal arm secured to the brake booster push rod. Do not pull or push on the brake pedal when removing or installing the speed control deactivator switch, as misadjustment or damage to the switch may occur.

1. Disconnect the speed control deactivator switch electrical connector.
2. Rotate counterclockwise 45 degrees and remove the speed control deactivator switch.

Installation

NOTE: When installing the speed control deactivator switch it is automatically self-adjusting to the proper position. Do not pull up or push down on the pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new switch.

1. Install the speed control deactivator switch, and rotate clockwise 45 degrees.
2. Connect the speed control deactivator switch electrical connector.