Side Impact Sensor - Front Door

SIDE IMPACT SENSOR - FRONT DOOR







Removal and Installation

WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Driver side shown, passenger side similar.

1. Depower the SRS.
2. Remove the front interior door trim panel.
3. Detach the rearward lower corner of the weathershield on the door to expose the side impact sensor.
4. Disconnect the side impact sensor electrical connector.

5. NOTE:
- Make sure the side impact sensor mating surfaces are clean and free of foreign material.
- Note the position of the side impact sensor locating tabs for installation.

Remove the bolt and the side impact sensor.
- To install, tighten to 9 Nm (80 lb-in).

6. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.

To install, reverse the removal procedure.

7. Repower the SRS.