Seat Position Sensor: Service and Repair

SEAT POSITION SENSOR







Removal and Installation

WARNING:
- Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
- Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Power seat shown, manual seat similar.

1. Position the front seat to the rearmost and upward position.
2. Depower the SRS.
3. Disconnect the electrical connector.

4. WARNING: Always tighten the seat position sensor retaining bolt to specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.

NOTE: Note the position of the seat position sensor locating tab for installation.

Remove the bolt and seat position sensor.
- To install, tighten to 6 Nm (53 lb-in).

5. To install, reverse the removal procedure.
6. Repower the SRS.