Window Glass - Rear Door

WINDOW GLASS - REAR DOOR

Exploded View

Part 1:

Part 2:

Removal and Installation
1. Remove the rear door trim panel.
2. Remove the rear door speaker.
3. Remove the interior moulding.
4. Remove the rear door weather shield.
5. Remove the rear door glass top run channel assembly bolt.
- To install, tighten to 12 Nm (9 lb-ft).

6. Remove the rear door below belt channel assembly nut.
- To install, tighten to 12 Nm (9 lb-ft).

7. CAUTION: Make sure the hole in the glass bracket does not become enlarged during the rivet removal process. Damage to the window regulator will occur if the hole becomes enlarged. The new rivet may become loose, resulting in a clicking noise concern.

NOTE: Use a 4.5 mm (0.1772 in) drill bit to drill out the glass-to-regulator rivets.

Remove the rear door window glass-to-regulator rivet.
- Position the rear door window glass as necessary to access the rear door window glass-to-regulator rivet.

8. Remove the applique on the rear door.
- Remove the screws.







9. Remove the rear door window glass.
- Pull the glass out through the top inboard side of the door.







10. To install, reverse the removal procedure.