Seat - Second Row, Bucket
SEAT - SECOND ROW, BUCKETExploded View
Second Row, 60 Percent E-Z Entry Backrest (Part 1):
Second Row, 60 Percent E-Z Entry Backrest (Part 2):
Second Row, 60 Percent, E-Z Entry Cushion (Part 1):
Second Row, 60 Percent, E-Z Entry Cushion (Part 2):
Second Row, 40 Percent E-Z Entry Backrest:
Second Row, 40 Percent, E-Z Entry Cushion (Part 1):
Second Row, 40 Percent, E-Z Entry Cushion (Part 2):
Second Row, Bucket, Backrest:
Second Row, Bucket, Cushion (Part 1):
Second Row, Bucket, Cushion (Part 2):
Second Row, 60 Percent Bench, Backrest:
Second Row, 60 Percent Bench, Cushion:
Second Row, 40 Percent Bench, Backrest:
Second Row, 40 Percent Bench, Cushion:
Material
Material:
Removal and Installation
NOTE: LH seat shown, RH seat similar.
1. Remove the front seat-to-floor nut and bolt.
2. Fold the affected bucket seat up to the E-Z entry position.
3. Pull up to release and remove the floor riser trim cover.
4. Remove the safety belt buckle bolt and the safety belt buckle.
5. Remove the 3 seat-to-floor bolts.
6. Remove the bucket seat.
Installation
1. Position the seat in the vehicle.
2. Tighten the retainers in the following sequence.
1 Apply threadlock and tighten to 40 Nm (30 lb-ft).
2 Tighten to 40 Nm (30 lb-ft).
3 Apply threadlock and tighten to 40 Nm (30 lb-ft).
4 Apply threadlock and tighten the remaining 2 bolts in any sequence to 55 Nm (41 lb-ft).
3. Position the safety belt buckle and install the bolt.
- Apply threadlock and tighten to 47 Nm (35 lb-ft).
4. Make sure the safety belt and buckles are accessible to the occupants after installation.