Operation CHARM: Car repair manuals for everyone.

Principles of Operation

PRINCIPLES OF OPERATION

NOTE: The smart junction box (SJB) is also known as the generic electronic module (GEM).

The SJB monitors the headlamp switch position by sending a voltage reference signal to the headlamp switch. When the fog lamp switch is engaged, the voltage reference signal is routed to ground.

When the low beam headlamps are on and the SJB receives an input from the headlamp switch indicating a request for the fog lamps, the SJB provides voltage to the fog lamp relay. When the fog lamp relay is energized, voltage is routed to the fog lamps.

Field-Effect Transistor (FET) Protection
The SJB utilizes a FET protective circuit strategy for many of its outputs (for example, the headlamp output circuit). Output loads (current level) are monitored for excessive current (typically short circuits) and are shut down (turns off the voltage or ground provided by the module) when a fault is detected. A continuous DTC is stored at the time of the fault. The circuit then resets after a customer demand of the function (switching the component on, battery saver being energized). When an excessive circuit load occurs several times, the module shuts down the output until a repair procedure is carried out. At the same time, the continuous DTC that was stored on the first failure cannot be cleared by a command to clear the continuous DTCs. The module does not allow this code to be cleared or the circuit restored to normal until a successful on-demand self-test proves that the fault has been repaired. After the on-demand self-test has successfully completed (no on-demand DTCs present), the continuous DTC clears and the circuit function returns.

Each circuit has 3 predefined levels of short circuit tolerance established in the module based on each circuits' capability. When the first or second level is reached, the continuous DTC associated with the circuit sets along with DTC B106E. These DTCs may be cleared using the Clear DTC operation on the scan tool as long as the fault itself has been corrected. If any of the circuits are shorted past the third level, then B106F and B1342 set along with the associated continuous DTC. These DTCs cannot be cleared and the module must be replaced.

The SJB FET protected output circuits for the fog lamp system are the LH fog lamp relay/fog lamps on indicator output circuits.