Rear Seat Backrest Cover

Seat Backrest Cover - Rear

NOTE: For component identification and locations, refer to Seat - Exploded View, Rear Rear Seat - Exploded View.

1. Remove the rear seat backrest. For additional information, refer to Seat Backrest - Rear Rear Seat Backrest.

2. Remove the head restraint(s).

3. Remove the 2 screws and latch cover.

4. Remove the 2 seat latch release handle screws.

5. Remove the seat latch release handle.

1. Detach the latch rod from the seat latch release handle.
- To aid installation, lock the latch using a flat-blade screwdriver before connecting the latch rod.

2. Remove the seat latch release handle.





6. Release the backrest cover J-clip.





7. Unzip the backrest trim cover zipper.





8. NOTE: The inboard and outboard head restraint guides are not interchangeable.

Squeeze together the tip of each head restraint guide and remove from the backrest frame.

- Note the alignment tab position for correct installation.





9. If 60 percent backrest, remove the 2 screws and safety belt shield.

10. NOTICE: Use care when separating the seat backrest trim cover from the hook-and-loop strip or the hook-and-loop strip can be torn from the seat backrest foam pad.

Separate the hook-and-loop strips and remove the seat backrest trim cover.

11. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.