Fog/Driving Lamp: Service and Repair

Fog Lamp

NOTE: Escape shown, Mariner similar.










Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

All vehicles

1. With the vehicle in NEUTRAL, position it on a hoist.

Escape

2. Remove the 4 fender splash shield bolts.
- To install, tighten to 5 Nm (44 lb-in).

3. Remove the 4 fender splash shield pin-type retainers.
- Position the fender splash shield aside.

All vehicles

4. Disconnect the fog lamp bulb electrical connector.

5. Release the 3 retainers and remove the fog lamp.

6. To install, reverse the removal procedure.