Seat Track

Seat Track

Removal and Installation

NOTE: For component identification and locations, refer to Seat - Exploded View, Front Seat - Exploded View, Front.

1. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

2. Remove the safety belt buckle pretensioner.
- Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.

- Detach the wiring harness pin-type retainer.

- Route the wiring harness from between the seat track and cushion frame.

3. Disconnect the electrical connectors, detach the wiring harness from the seat track.
- If driver seat, disconnect the seat position sensor electrical connector.

- If equipped, disconnect the power seat motor electrical connector.

- Detach the seat harness electrical connector from the seat track.
- Note wiring harness routing for correct installation.

4. Remove the 4 seat track-to-cushion frame bolts.
- To install, tighten to 25 Nm (18 lb-ft).

5. To install, reverse the removal procedure.
- Transfer components as necessary.