Air Conditioning System Overview

Air Conditioning



Air Conditioning System Overview

NOTE: All component descriptions contained in this system description are common for both non-hybrid and hybrid Escape/Mariner vehicles unless specified otherwise.

The refrigerant system components include the following:

- Pulley driven A/C compressor and clutch assembly (non-hybrid)
- Electric A/C compressor (hybrid)
- A/C compressor clutch assembly (non-hybrid)
- A/C condenser core
- A/C evaporator core
- Receiver/drier
- Connecting refrigerant lines
- Thermostatic Expansion Valve (TXV)

The refrigerant system incorporates an A/C compressor controlled by the PCM through an A/C clutch relay. The HVAC module sends an A/C request signal to the Instrument Cluster (IC), which relays the request to the PCM. An evaporator discharge air temperature sensor is used to cycle the A/C compressor off when the evaporator core temperature falls below an acceptable temperature.

The HVAC module will send an A/C request signal to the IC if the ambient temperature is above approximately 35°F (2°C) and any one of the following conditions are met:

- A mode which requires A/C operation has been manually selected by the driver.
- The driver selects the A/C button while operating in manual mode.
- A/C is operating automatically via AUTO mode and the driver has not deselected A/C operation.

NOTE: For non-hybrid vehicles, the HVAC module will also require the evaporator discharge air temperature sensor to be reading an acceptable evaporator core temperature before sending an A/C request to the PCM. For hybrid vehicles, the HVAC module will send the A/C request to the PCM as well as relaying the evaporator discharge air temperature sensor reading to the PCM. The PCM will then cycle the A/C compressor ON or OFF based on the sensor reading.

When an A/C request is received by the PCM, the A/C compressor will only be engaged through the A/C clutch relay if all of the following conditions are met:

- The evaporator discharge air temperature sensor is reading an acceptable temperature.
- The low-charge protection switch is not open due to excessively low refrigerant pressure.
- The A/C pressure transducer is reading an acceptable pressure in the high-pressure side of the refrigerant system.
- The engine coolant temperature is not excessively high.
- The PCM has not detected a Wide Open Throttle (WOT) condition.

An A/C pressure relief valve is installed to protect the refrigerant system against excessively high refrigerant pressures.

Refrigerant flow into the evaporator core is metered by a TXV.