Flexplate

Flexplate

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the automatic transaxle. For additional information, refer to Automatic Transaxle/Transmission - 6F35 Removal.

3. Remove the 6 bolts and the flexplate.

Installation

1. NOTE: Special bolts are used for installation. Do not use standard bolts.

Install the flexplate and tighten the bolts in the sequence shown in 3 stages.

- Stage 1: Tighten to 50 Nm (37 lb-ft).

- Stage 2: Tighten to 80 Nm (59 lb-ft).

- Stage 3: Tighten to 112 Nm (83 lb-ft).





2. Install the automatic transaxle. For additional information, refer to Automatic Transaxle/Transmission - 6F35 Removal.