C-Pillar Trim Panel

C-Pillar Trim Panel

Removal and Installation

1. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.

Remove the safety belt D-ring bolt cover.





2. Remove the safety belt bolt.
- To install, tighten to 48 Nm (35 lb-ft).





3. Remove the quarter trim panel. For additional information, refer to Quarter Trim Panel Quarter Trim Panel.

4. Position the rear door opening weatherstrip aside.

5. Release the C-pillar coat hook by inserting a small flat screwdriver in the slot at the base of the coat hook.





6. Remove the coat hook.
- For LH coat hook, twist clockwise.

- For RH coat hook, twist counterclockwise.

7. Remove the C-pillar trim panel bolt.
- To install, tighten to 7 Nm (62 lb-in).

8. NOTICE: To avoid damage to the C-pillar trim panel, remove any retaining clips from the body and attach them to the C-pillar trim panel before installing.

Remove the C-pillar trim panel by pulling straight outward to release the retaining clips.

9. To install, reverse the removal procedure.