Rear

Transaxle Support Insulator - Rear

Transaxle Support Insulator - Rear









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the rear insulator through bolt.
- To install, tighten to 115 Nm (85 lb-ft).





3. Remove the rear insulator nuts and bolt.
- To install, tighten to 80 Nm (59 lb-ft).





4. Remove the rear insulator studs.
- To install, tighten to 12 Nm (106 lb-in).





5. Remove the rear insulator.





6. If necessary, remove the 3 bolts and the transaxle rear support insulator bracket.
- To install, tighten to 80 Nm (59 lb-ft).

7. To install, reverse the removal procedure.