Seat Cushion - Driver

Seat Cushion - Driver

NOTE: Power seat track shown, manual similar.











Disassembly

1. Remove the seat backrest. For additional information, refer to Seat Backrest - Front Seat Backrest - Front.

2. Remove the safety belt buckle pretensioner.
- Disconnect and detach the safety belt buckle pretensioner and buckle switch electrical connectors from the seat track.

- Detach the wiring harness pin-type retainer.

- Route the wiring harness from between the seat track and cushion frame.

3. Disconnect the electrical connector(s).
- Disconnect the seat position sensor electrical connector and detach the wiring harness.

- If equipped, disconnect the power seat track electrical connector and detach the wiring harness.

- Detach the seat harness electrical connector from the seat track.

4. Remove the 4 bolts and seat track.
- To install, tighten to 25 Nm (18 lb-ft).

5. If equipped, disconnect the cushion heater mat electrical connector.

6. NOTICE: Use care when separating the seat cushion trim cover from the hook-and-loop strips or the hook-and-loop strips may be torn from the seat cushion foam pad.

Release the all the retainers and remove the cushion cover.

7. Remove the cushion foam pad.
- If equipped, note heater mat wire harness routing for correct installation.

8. If equipped, release the locking tab and remove the heated seat relay from the bracket on the cushion frame.
- Disconnect the relay electrical connector.

9. To assemble, reverse the disassembly procedure.