Inspection and Verification
Inspection And Verification
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Blistering or swelling of rubber brake components can indicate contamination of the brake fluid by a petroleum-based substance. The entire hydraulic brake system must be flushed with clean, specified brake fluid and contaminated rubber components must be replaced to prevent recontamination.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
On a conventional brake system, the first indication that something may be wrong in the brake system is a change in the feel through the brake pedal. The brake warning indicator in the Instrument Cluster (IC) and the brake fluid level in the brake master cylinder reservoir are also indicators of system concerns.
If a wheel is locked and the vehicle must be moved, open a bleeder screw at the locked wheel to let out enough fluid to relieve the pressure. Close the bleeder screw. If multiple wheels are locked, check the brake pedal free play to verify brake pedal is not partially applied. These operations may release the brakes, but will not correct the concern. If this does not relieve the locked wheel condition, repair the locked components before proceeding.
1. Verify the customer concern.
2. Visually inspect for obvious signs of mechanical or electrical damage.
Visual Inspection Chart
- For parking brake concerns, refer to Parking Brake and Actuation Testing and Inspection.
- For vacuum pump (hybrid vehicles) concerns, refer to Vehicle Dynamic Systems Testing and Inspection.
- For ABS concerns, refer to Vehicle Dynamic Systems Testing and Inspection.
- For brake-by-wire (hybrid vehicles) concerns, refer to Vehicle Dynamic Systems Testing and Inspection.
- For active brake booster (hybrid vehicles) concerns, refer to Vehicle Dynamic Systems Testing and Inspection.
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the cause is not visually evident, refer to GO to Symptom Chart - Brake System (Non-Hybrid Vehicles) or GO to Symptom Chart - Brake System (Hybrid Vehicles). Symptom Chart - Brake System
5. If a brake system concern is not evident, visually inspect the suspension system and tires for obvious signs of wear or damage.
- For suspension system concerns, refer to Suspension System - General Information Testing and Inspection.
- For tire concerns, refer to Wheels and Tires Testing and Inspection.