Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor





Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the retainers and the LH splash shield.





3. Disconnect the Turbine Shaft Speed (TSS) electrical connector, remove the bolt and the TSS sensor.





Installation

1. Install the TSS sensor, the bolt and connect the TSS electrical connector.
- Tighten to 10 Nm (89 lb-in).





2. Install the LH splash shield and the retainers.





3. Fill the transaxle with clean transmission fluid.

4. Using the scan tool with the engine running, check and make sure that the transmission is at normal operating temperature 85-93°C (185-200°F). Check and adjust the transmission fluid level and check for any leaks. If transmission fluid is needed, add transmission fluid in increments of 0.24L (0.5 pt) until the correct level is achieved.