Heater - Excessive Air Velocity On Driver's Leg
83ford9Article No. 83-18-7
HEATER - EXCESSIVE AIR VELOCITY ON DRIVER'S LEG
FORD 1982-83 FORD CROWN VICTORIA
LINCOLN-MERCURY 1983 LINCOLN TOWN CAR, MERCURY GRAND MARQUIS Excessive air velocity on driver's leg may generate a customer concern. A diverter can be fabricated and installed on the floor duct to direct air away from flowing directly on the driver's leg.
FIGURE 10:
Modification:
1. Construct a sheet metal diverter from 1/64"-1/16" sheet metal using dimensions in Figure 10. (Figure 10 can be used as a template).
2. Bend the diverter into a 90~ angle at the bend line by lifting upward on the left edge while retaining the diverter down with a straight edge on the bend line.
FIGURE 11:
3. Using black duct tape, install the diverter into the left floor outlet (Figure 11).
4. When taping the diverter in place, be certain not to tape over the bottom of outlet. This service does not require the removal of the floor duct.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP18433A83
TIME: 0.4 Hr. DLR. CODING: Basic Part No. 18633 Code: 37