Horn Switch: Service and Repair

Fig. 3 Turn signal, hazard, horn, flash-to-pass & dimmer switch:

MODELS LESS PASSIVE RESTRAINT SYSTEM
1. Disconnect battery ground cable.
2. Remove 5 shroud screws, then the lower shroud.
3. Remove upper shroud assembly...
4. Grasp switch lever and pull lever straight out from switch assembly, Fig. 3.
5. Peel back foam switch cover from turn signal switch.
6. Disconnect 2 electrical connectors.
7. Remove 2 self tapping screws attaching switch assembly to lock cylinder housing, then disconnect switch from housing.
8. Reverse procedure to install.