Compressor

HR-980 Four Cylinder Compressor
1. Discharge refrigerant from system.
2. Disconnect compressor clutch wires at the field coil connector on compressor.
3. Disconnect discharge suction hoses from the compressor manifolds. Cap refrigerant lines and compressor manifolds to prevent the entrance of dirt and moisture.

Fig. 39 Four cylinder compressor removal:

4. Remove screw and washer assembly from the adjusting bracket, Fig. 39.


5. Rotate compressor outboard and remove drive belts.
6. Remove compressor mounting bolt attaching bracket to compressor lower mounting lug.
7. Remove compressor and adjusting bracket as an assembly.
8. Reverse procedure to install.