Technical Instructions Attachment III

FIGURE 1:

ATTACHMENT III


SAFETY RECALL 91S28
POWER FRONT SEAT SWITCH WIRE HARNESS ROUTING


TECHNICAL 1NSTRUCTIONS

1. Remove the two (2) nuts and two (2) bolts retaining the seat and track assembly to the floor pan.

2. Disconnect the battery ground cable.

3. Lift the seat and track assembly high enough to disconnect the power feed and seat belt warning light wires.

4. Tilt the seat backward for an unobstructed view of the seat control switch wiring. Disconnect the wiring at the connector. (See Figure 1).

5. Remove the seat and track assembly and place it on a clean work area.

6. Remove the seat control switch wiring (pigtail) from between the seat springs and seat support bracket.

7. Inspect the switch wiring (pigtail) for damage, such as abrasion,
punctures or chaffing in the cloth wire-wrap.

8. Using electrical tape, repair any wires that are damaged. If damage to the switch wiring is too extensive to repair, replace the switch assembly (Part Number E6DZ-14A701-A).

9. Connect the seat control switch wiring (pigtail) to the wiring harness and reroute the wiring as shown in Figure 1.

10. Position the seat and track assembly to the floorpan.

11. Reconnect the power feed and seat belt warning light wires.

12. Reconnect the battery ground cable.

13. Install tbe seat track-to-floorpan attaching bolts and nuts. Tighten the bolts and nuts to 8-18 lb.ft. (12-24 N-m) torque.

14. If the car is equipped with both driver and passenger side power seats, repeat the procedure on the opposite side.

15. Check the seat track for proper operation.